All nodes
CC-WTR · DraftConcept only

Water node

Know how full your tanks are, and run the pump and valves from anywhere.

A render of the water node in its printed case, with each terminal and both fuses labelled on the lidA render of the water node's circuit board, with button and level terminals along one edge, valve and temperature terminals along the other, and two fuse holders

What it does

The water node keeps track of your fresh and grey tanks and runs the pump. It reads two tank senders and reports the levels over the cable, so they show up on the command centre screen without any extra wiring.

The node switches the pump itself, at up to 7.5A, so it needs its own power feed rather than the shared line. The pump usually sits at one end of the van with the tank, so the switch would normally need its own wire the length of the van. Here the switch can be on any controls node, or you can skip the switch and use the command centre screen.

It also opens and closes two motorised ball valves, at up to 2A each. Three button inputs take ordinary switches for the pump and each valve. The pump and the valves have their own fuses on the board.

It can also run on its own: cut the pump when the fresh tank runs dry, or switch it off when you start driving. Two temperature sensors watch the fresh and grey tanks. A frost alert is planned, so the system can warn you before the water gets near freezing.

Specifications

Tank senders2
Temperature sensors2 x DS18B20
Pump output7.5A
Valve outputs2, 2A each
Button inputs3
Supply12V/24V
Size95mm x 70mm
Concept onlySpecs subject to change

Would you fit this in your van?

CamperCan is in the prototype stage. Tell us what you'd use it for and what you'd like to see, and we'll keep you posted.

Register interest