All nodes
CC-TRM · DraftConcept only

Terminator

One on each end of the cable keeps the nodes talking cleanly.

A render of the terminator in its printed case, with H and L marked beside the terminal openingsA render of the terminator's circuit board, a small square with one two-way screw terminal

What it does

The terminator is a tiny board with a 120 Ω resistor and a screw terminal. One goes on each end of the CAN bus cable, wired across the two data wires.

A CAN bus needs a resistor at both ends to stop signals bouncing back along the cable. Without them the nodes can struggle to hear each other. The nodes have no termination of their own, so every install needs two terminators.

It comes in a small printed case that snaps together with no screws. The case marks which terminal is CANH and which is CANL.

Specifications

Resistance120 Ω
Wire sizeUp to 0.5mm²
Size14mm x 13mm
Concept onlySpecs subject to change

Would you fit this in your van?

CamperCan is in the prototype stage. Tell us what you'd use it for and what you'd like to see, and we'll keep you posted.

Register interest