All nodes
CC-RLY · DraftConcept only

Relay node

Switch six loads, mains or 12V, from anywhere in the van.

A render of the relay node in its printed case, with each relay's terminal and rating labelled on the lidA render of the relay node's circuit board, with six white relays in the middle, a row of button terminals along one end and a large black terminal for relay 6

What it does

The relay node switches six loads on and off. Five relays take up to 10A each and the sixth takes up to 25A. Each one can switch 230V mains or 12V and 24V DC, in any mix, so mains and low-voltage loads can share one node.

Each relay is a plain switch between its two terminals. The node feeds nothing to the loads, so bring a fused supply to one terminal and wire the load to the other. The ratings are for steady loads. Stay well under them with motors, pumps and anything else that draws a surge.

Six button inputs take ordinary switches, and what each one does is a setting, not a wiring job. Over the cable, the command centre and any other node can switch the relays too.

Mains wiring can kill. Have it done or checked by someone qualified. The printed case is not a certified enclosure, so print it in a flame-retardant material if it will hold mains.

Specifications

Relays6
Relays 1 to 510A each
Relay 625A at 230V AC, 20A at 12V DC
Switches230V AC, 12V/24V DC
Button inputs6
Supply12V/24V
Size134.5mm x 70mm
Concept onlySpecs subject to change

Would you fit this in your van?

CamperCan is in the prototype stage. Tell us what you'd use it for and what you'd like to see, and we'll keep you posted.

Register interest