All nodes
CC-CLM · DraftConcept only

Climate node

Set a temperature and the heater holds it.

A render of the node in its printed case, with each terminal labelled on the lidA render of the node's circuit board, with rows of green screw terminals along three edges

What it does

The climate node runs your diesel heater and keeps an eye on the temperature. It supports the Autoterm Flow 5D and reads a DHT22 sensor for temperature and humidity.

Set a target on the command centre and the node turns the heater up and down to hold it, like a thermostat at home, so the van stays warm through the night without you touching it. Turn it on from your phone on the walk back and the van is warm when you arrive.

A 15A output drives a fan, so it can vent the van when it gets too warm. Temperature readings go over the cable, so you can see them on the command centre, look back at the history and use them in automations.

Specifications

Heater supportAutoterm Flow 5D
Fan output15A
Temperature sensorsDHT22
Supply12V/24V
Size65mm x 70mm
Concept onlySpecs subject to change

Would you fit this in your van?

CamperCan is in the prototype stage. Tell us what you'd use it for and what you'd like to see, and we'll keep you posted.

Register interest